Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateClopay Weather Seal Replacement: The Fort Lauderdale Owner’s Guide
Clopay weather seal replacement in Fort Lauderdale typically runs $110 – $220 installed, depending on your door’s width and whether the bottom seal, side seals, or both need replacing. We stock Clopay-compatible seals on our trucks, which means most replacements are handled in a single visit, often same day. If you’re seeing daylight under the door, finding water on the garage floor after a South Florida downpour, or noticing more bugs and humidity inside than you used to, the weather seal has likely called it quits.
The part itself looks simple: a rubber strip that runs along the bottom of the door and up the sides. But Fort Lauderdale’s heat, salt air, and rainy-season humidity eat rubber faster than most homeowners expect. What starts as a small gap along one corner becomes a full failure within a season. Wade Mercer has replaced enough of them in neighborhoods from Victoria Park to Coral Ridge to know that a Clopay door with a solid seal keeps out more than just water: it keeps out the damp, the pests, and a big slice of your cooling bill.
Which Clopay Models This Applies To
We replace weather seals on Clopay residential doors across their current and legacy lines: the Gallery, Reserve, Canyon Ridge, Coachman, Bridgeport, and Classic series. The seal itself is not one universal part. Clopay uses a T-style or bead-style bottom seal that slides into an aluminum retainer channel screwed to the bottom rail of the door. The retainer profile and seal size differ between models: older Classic steel doors often use a 3-inch T-seal, while newer insulated doors and the Canyon Ridge carriage-house line typically take a 4-inch T-seal or a bulb-style seal in a wider channel. Getting this wrong means the seal binds, falls out, or doesn’t compress against the concrete.
If you’re not sure which seal your door needs, look for the part number sticker on the bottom rail or the inside of the top section. Clopay stamps model information there on doors made after roughly 2005. No sticker, no problem: we identify the retainer profile by sight and measurement during the visit.
On the OEM-versus-aftermarket question: Clopay’s own replacement seals are good quality, but they carry a premium price and often have to be ordered, which means waiting a few days in Bradenton before a Fort Lauderdale door gets fixed. Quality aftermarket T-seals and bulb seals made from EPDM rubber match or beat the OEM compound for South Florida conditions. EPDM resists UV degradation and salt air better than the PVC seals used on some older Clopay doors. We use EPDM when the application allows it, because in this climate, the sun is the part that fails most, not the door.
Brock Garage Doors Fort Lauderdale is an independent service provider. We’re not affiliated with Clopay, but we’ve been trained on their systems, stock compatible parts, and know their models well enough that the seal fits right the first time.
Styles & brands we work with






Signs Your Clopay Weather Seal Replacement Is Failing
- Daylight visible under the door. The seal has compressed, torn, or pulled free of the retainer. A door that doesn’t sit tight against the floor lets outside air, bugs, and runoff water inside.
- Water pooling near the garage door after rain. Fort Lauderdale’s summer storms push water sideways. If the bottom seal can’t make full contact, driven rain walks right under the door and pools on your slab.
- Higher humidity or a musty smell in the garage. A failed seal lets South Florida’s ambient moisture inside, which feeds mold on stored boxes and rusts bare metal on tools and garage equipment.
- Pest activity increasing. Roaches, palmetto bugs, and rodents enter through gaps far smaller than you’d think. The garage door bottom is the classic entry point, and a hardened or torn seal doesn’t block them.
- Visible cracking, flattening, or brittleness on the seal itself. Run a finger along the seal. If it feels stiff or crunchy rather than pliable, the rubber has oxidized. Once that happens, it stops conforming to the slab and needs replacement rather than adjustment.
Replacement Cost & What’s Included
What does Clopay weather seal replacement cost in Fort Lauderdale? Most jobs run $110 – $220 for a standard double garage door, parts and labor included. Single-car doors fall toward the bottom of that range. If you have a wider door, a damaged retainer that also needs replacing, or want both bottom and side seals done at once, the price moves up but stays transparent.
Here’s how the pricing breaks down, so nothing surprises you on the invoice:
- Bottom seal replacement (parts and labor): $110 – $180
- Side and top seal replacement: $130 – $220
- Full perimeter seal (bottom, sides, and top): $180 – $220
- Retainer replacement (if aluminum channel is bent or corroded): $40 – $70 added
The number we quote on the phone is the number we put in writing before any work starts. It’s the number on your invoice. That’s not a policy we bend on: it’s a Garrison Standard that’s been in place since 2001. If the retainer channel is corroded and we discover it mid-job, we stop, show you what we found, and give you a revised written price before proceeding. Nothing gets added at the end.
Every weather seal replacement carries the 365-Day Done Right Promise in writing. If the seal fails within a year, we come back and make it right at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Weather seal replacement is one of the few garage door repairs that doesn’t involve high-tension springs or cables, so the risk of serious injury is low. If you can operate a screwdriver and get down to floor level, you can slide an old T-seal out and a new one in. The honest split comes down to two things: getting the right seal profile for your Clopay retainer, and dealing with a door that’s no longer sitting level.
If the door isn’t closing evenly, a new seal won’t fix the gap. The problem is in the travel limits, the spring tension, or the track alignment, and a fresh seal will just wear out faster while the real issue goes unaddressed. That’s the point where DIY costs you more than calling us first. Tell me what it’s doing and I’ll tell you what it needs.
If you’d rather not spend an hour on your knees with a rubber strip that refuses to cooperate, call (754) 354-7491. We’ll bring the right seal, handle the swap in a single visit, and give you the written price before we touch the door.
FAQs
In Fort Lauderdale’s heat, salt air, and hurricane-season moisture, expect a Clopay weather seal to last three to six years before the rubber hardens or tears. Doors facing direct western sun or with heavy daily usage sit on the shorter side of that range. A seal that’s gone hard by year three was likely a PVC compound; switching to an EPDM seal typically buys more time. Call (754) 354-7491 and we’ll advise you honestly on what will last.
No. Once weather seal rubber has torn, cracked, or hardened, no adhesive or patch returns it to service, because the seal needs to compress uniformly along its full length to keep water and air out. We replace it. The only exception is a seal that’s simply pulled loose from the retainer but is still pliable, which we can sometimes reseat. Call (754) 354-7491 and we’ll tell you which situation you have.
Most Clopay weather seal replacements take 30 to 60 minutes, including removing the old seal, sliding in the new one, and checking the door’s contact with the floor around the full perimeter. If the retainer itself needs replacement, add another 30 minutes. We schedule a one-hour window and show up when we say we will.
Yes. Our service trucks carry the common Clopay T-seal and bulb-seal profiles for both 3-inch and 4-inch retainers, along with side and top seal stock. If your door has an uncommon retainer or an oversized width, we’ll measure, confirm the right part, and get it back on the schedule within a few business days, no guesswork on your end. Call (754) 354-7491 and we’ll confirm what’s needed before the truck rolls.
Call Brock Garage Doors Fort Lauderdale for Your Clopay Weather Seal Replacement
If your Clopay door is letting water, bugs, or humidity into the garage, don’t wait for the seal to fail completely. Call Brock Garage Doors Fort Lauderdale at (754) 354-7491 for a free estimate. A live person answers day or night, including weekends. We’ll tell you over the phone what the seal replacement should cost for your door, then put the number in writing before we begin. The work is backed by the 365-Day Done Right Promise, in writing, on every job. We stock Clopay-compatible seals on the truck and service doors in Fort Lauderdale, Oakland Park, Wilton Manors, and the surrounding area. One call, straight answer, seal replaced.
Written by Wade Mercer, Owner, Brock Garage Doors Fort Lauderdale at Brock Garage Doors Fort Lauderdale, serving Fort Lauderdale and nearby areas.